- AGP WGA with PTP Spring......what to set it at with stage 1
- I'm having problems on the Dyno!Boost Drops, & Surges!!!
- tried for 300whp didnt happen
- Boostn Help
- Budget Turbo Dyno Results!!!!
- Stage 0 and safc need serious help
- fmic pictures
- What next: AGP WGA or Maxxfab DP?
- lube on inserts?
- Breather Filter
- Need advice on future turbo plans
- What to use as a 'voltage switch' for PTB eliminator ?
- which bov?
- Flutter Noise
- dule boost controler
- Bov-diff. Springs???
- Stage 2 WGA
- Stock Turbo Boost Maximum
- Using emanage/e-01 to control water injection
- Stoked
- Stoked
- Stoked
- boombo fuel rail ?
- Stage 1: instant "plug-in-and-go" gains or "learned" performance?
- HELP!!...question about reading map voltage
- AGP Billet WGA Question
- How high can I raise my boost safely??
- need some guidance
- forge wga installed... have some q?'s
- Boost Leak Question
- Need help on prothane MM Inserts
- Stage 2 or turbo back exaust???
- modern performance customer service question?
- stock cat + sniffer, a/f accuracy? dyno sheet inside
- Running mopar and hks bov same time???
- This noise is killing me - help troubleshoot
- help with RPM's hanging
- does ANYONE have a WORKING mopar bov how-to?
- Didnt know where else to post this......
- back pressure
- Type S
- the biggest leak in the world...
- Will Crane 14's Work??
- another wga question
- Stg3 owners tell me your spoolup.......
- Mopar info......?
- S2 w/toys + kinetic WGA question
- What To Do Next
- Funny Smell?
- opinios ebay dowpipes tsudo,greddy,xtune
- performance-trends boost controler?
- traction with stage 3
- Bov-louder Boomba Or Forge??
- MBC problems
- Is stage 1 worth it for my mods?
- Ed side exit exhaust?
- need some serious help!!!!!!
- is this hurting my performance?
- Looking for an exaust..need opinions. :-)
- Injector question
- Stg2 Map sensor on Stg1 Pcm
- new srt-4 owner and dont know where to start!
- A/F gauge help asap!!
- TurboSmart Boost TEE what do i need....
- Quick Question about my BOV
- mopar cai/dc sports strut tower brace alignment
- surge?
- Block off Plate vs No Block Off Plate
- DCR Mod ROCKS!!!
- Clutch feedback?
- muffler idea...
- Stinky Srt ?
- perrin bov
- AEM Short Ram Intake Help!
- best exhaust ?
- Stock Internals
- Air fuel controller?
- Stage 2 no toys question.
- why need miles for stages?
- The SRT-4's Potential...
- stage two asap please help!
- clutch goin at 12k miles
- Surge Valve
- Forge WGA HELP
- Never had a STS, here's my thoughts on a Maddog.
- can someone post a pic of the tranny mount?
- how to install
- Super Boost!?!?
- mbc install
- Dynoed today...
- who make a good shift knob?
- boostin 0 with the new agp wastegate, can somebody tell me what wrong??
- got dynoed...
- 4" intake
- Question on JMB ultimate CAI and CAI in general
- AEM CAI install instructions needed !
- 02 pipe installation
- T67 and Fuel Question....
- Stage 2 install, what a nightmare
- Jackstands!?!?
- Lower motor mount, where is it?
- catch can not catching enough oil.
- Custom Manual 3in Cut-Out Downpipe
- check engine light after boost controller install
- 20PSI with a Toggle switch, HOW?
- stage 1 boost levels
- Boomba BOV
- Engine Mounts
- Injen DP owners need pics of your dp please
- Dasmopar Map clamp install
- Intercooler pipes
- Blitz DTT w/Boost Gauge
- Question about exhaust
- Wga Help!!!
- Just installed boost gauge, question about top dash..
- need help quick!
- stage 2w/toys wiring instructions
- How does everyone have there wideband setup?
- Wideband question??? HELP
- Where to get an o2 housing with 2 bungs????
- AGP BOV conversion plate, leak or no leak?
- Stage 2
- Snow Performance?
- C-16 fuel cell in trunk....
- tuning
- return line ?
- ***Boost Controller ???***
- S2 WGA w/ S0 or S1 PCM
- GReddy Remote Boost Switch
- need serious help, 60trim installed, p0172???
- Help With Aem Cai Installation???
- polished radiator shroud
- Stage 3R turbo outlet size?
- MaxxFab SEE vs DTBE (modified Borla system) Owners Thoughts?
- Used stage 2 w/toys.. Will it work if toys are not installed?
- Better clamps to fix the leaking stockers. We have a kit for you.
- ***Problem with my AGP Wastgate actuator****
- Modding MOPAR BOV (eliminate blow-off when not under boost)
- MOPAR BOV vs. Forge Motorsport Blow Off Valve
- match up ? (mods vs. 350z)
- cheapest for stage2 and stage2 w/
- Eliminating the Factory Boost Leak known as the Vaccuum Ejector
- TB question
- modified borla with gt3071R?
- Boost in DAB 3 on Stage 2
- newb question
- stage 2 suffering?????
- Stock VAC lines kenetic WGA
- Mopar CAI Installed
- Running Direct Port N20?Help Me Out.
- more stage 2 problems
- Maddog STS
- When engine is COLD what's ur VAC. at???
- how to get traction
- AGP Wastegate....setup suggestions.....
- Boogers review
- Hks Owners
- SRT-4 Turbonetics Pressure Pipe with Raptor BOV
- Max ptb?
- Stock srt-4 versus stock 2005 evo from roll..
- Mopar cat delete without mid pipe?
- quick intake ?
- Money ready to be spent
- ok "yea" or "no" and why
- 50Trim or 3071R w/HRC Portfueler
- greddy bov ebay new less than50??
- weird noise???
- Shock from Engine
- quick question....
- Anyone running a TurboSmart Vee Port BOV...
- code P1188 FIX!
- shooting for 300 whp....
- Water injection question
- fmic
- Shift Tite Bushings are smoother than Booger Bushings ...
- waitin for thepowertowin to say ::::
- Leak at BOV question
- Stage 2 without Tip or Injectors ?
- Boost gauge flutter or leak??
- PTP needs a stage 3 test car, new big wheel.
- MAddog 80% STS installed in 40 minutes!!!
- Stage 1 compatibility
- Boost gauge problems. Need info.
- Injen or JMB?
- stock vacuum line/ soleniod setup
- benefits of working at a dealership
- Thermal R&D Exhaust?
- Traction????
- stage 1 help
- lower motor mount.
- More Bov Help!!!
- Engine shake issue at low boost?
- Electronic Boost Controllers ?
- Dump Cutout Exhaust Y pipe Question
- what about this muffler?
- Perrin Short Throw & Viper knob...
- kinetic wastegate problem...overboosted!
- Downpipe and Exhaust Remove the reducers
- Hks Bov Insert Help!!!!!!
- Turbo XS RFL knockoff ?
- Boost problems
- Who can use our minifold
- wideband, wiring diagram ex fix?
- 50 trim / e-01 vacuum line routing??
- Map Clamp Wire Install Area
- stage2 questions
- new setup questions
- Mopar Stage II questions
- Aem SR intake fit with AGP kit?
- MagnaFlow Exhaust?
- type s adjusting
- torque specs on high strength mm bolts?
- Factory Inside Diameter Size of Throttle Body, Spacer, and Intake Manifold
- needswinds e-cutout problems?
- Traction Bars Info
- 400whp??
- TiAL BOV problems
- Larger throttle body = better gas mileage?
- need 60 mm TB & 3" 02 housing quickly
- Need help with modded stock WGA on stage 2
- Modified Borla Exhaust
- stage 2 with stage 3 turbo
- my exhaust hangs low??
- Water Injection Mod = Heaven ....
- Boost controller on stage 1??
- MAP Clamp+DASMOPAR is gone?
- Crack in revised HP Racing Manifold...
- is my car ok?
- Would the stock WG be better if running EBC???
- 2 questions, i need some help
- 1000cc injectors and a Standalone
- 5psi with engine off
- 3'' to 2.5 exhaust
- Is it worth it???
- gt3071r/76r on stage 2 pcm (w/toys) ???
- Boost Problem
- WTF? I melted through my MSD wires!!
- my vac pressure falls to 24 when i let off the throttle?
- 3inch exhaust stright pipe nothing at all
- stock surge valve emergency!
- How to install shims/washers in the RFL BOV
- stock BOV (surge valve) question
- Compressor Surge and Bypassing the Solenoid
- Stage 2 w/o toys with bolt ons
- gauge ???
- how often to check
- HELP!! PTP MAP?TIP clamp install
- need hp
- Stage 2 WGA on Stage0 and Stage1
- Gas mileage difference stage 1 and mopar catback?