Quote: Originally Posted by toasteroven
I... Removed the harness by twisting counter-clock 1/4 turn and re-routing in front of the clutch and zip-tying... however the words "DO NOT RE-INSTALL" are boldly printed on the harness... hope that means nothing
This was in the service manual:
Code:
CAUTION: Do not reuse the original brake lamp
switch. This switch can only be adjusted once. That
is during initial installation of the switch. If the
switch is not adjusted properly or has been
removed for some service, a new switch must be
installed and adjusted.
So... Is there someway to re-route without messing with the switch???
