Quote: Originally Posted by
phrozen 
what is the CEL? you shouldn't have one if the resistor is installed.
P0073 ambient temp sensor high
the ambient temp sensor voltage is greater than 4.9 volts one trip fault
Maybe I don't have the connector all the way clipped on my airbox? Isn't that the right sensor?
Side note:
Took a few runs today to and from work. Got 2-5 set for 10 psi and it's very close. It does overshoot to say 13 but then drops right back down to just below 10. I have my learning @ 8 so maybe I should change it to 5 or so? Would that get rid of the little spike's?
