Using A Long Screwdriver Or An Old Antenna Poke A Hole Through The Grommet At The Firewall As Show In The Picture And Tape The Black 16 Gauge, Blue And Green Wires From The Boost Controller Harness And Pull It Through The Firewall And Into The Engine Bay As Shown.
LOCATE THE TPS CONNECTOR WHICH IS LOCATED ON THE THROTTLE BODY ASSEMBLY AS SHOWN IN THE PIC ABOVE.
ROUTE THE BLUE WIRE FROM THE ELECTRONIC BOOST CONTROLLER TO THIS LOCATION
SPLICE THE BLUE WIRE FROM THE BOOST CONTROLLER HARNESS TO THE MIDDLE PIN OF THE TPS CONNECTOR WHICH IS THE ORANGE/DARK BLUE WIRE.THIS IS THE TPS SIGNAL WIRE.
BE SURE TO SOLDER AND SHRINK TUBE ANY EXPOSED WIRING
IF YOU HAVE A WOTBOX ALREADY INSTALLED IN YOUR CAR YOU CAN WIRE THE BLUE WIRE FROM THE BOOST CONTROLLER TO THE BLUE WIRE ON YOUR WOTBOX HARNESS
