AGP wga questions
I just installed one of the AGP wga's and I must admit it gives a pretty significant power boost, but I have some questions I was unable to find answers for here on the forums.
Car runs great except if I try to go WOT at anything much under 3k RPMs. If I try to do this it kinda stumbles and misses a few times then takes off like nothing is wrong. I was just curious what this might be.
I installed the gate per the instructions with the vac line ran off of the green line on the rear of the compressor with the supplied bleed. When I preloaded the spring I ran it up to finger tight then went an additional round on the adjustment nut. After the first test drive like this my boost was a little low so I preloaded it an additional 1/2-3/4 of a round and that is when my miss started to appear. Boost is spiking out to around 17-18 and holding around 14 to redline which is about where I wanted to be, but the miss/stumble at low RPM w/ WOT concerns me a bit.
Any suggestions would be helpful perhaps I need to run a larger diameter vac supply line from the compressor housing to the WGA? maybe turn the boost down some? or could all of this be caused by having stock plugs? Or maybe this is just that part throttle boost thing I here about? I do not know but if anyone has ever seen this please help me out. Thanks
Mods: Stage 1, Mopar CAI, Maxxfab SEE w/o cat
|
