Include

[nineball]

i spent about an hour trying to figure out how i would be able to wrap this and could not come up with a solution, so out came the saw. cut the boxes down into platforms matching the footprint of the amps and made mounting bases for them, then cut a base plate for the entire thing.






then did a quick fit test to see where i was at.









cut off the corners in a little wave pattern to give it a nicer look and sanded down all the outside edges.





back in the trunk. no, the rings are not mounted. they are just sitting there for looks.









and that was all for today. did a guesstimation on the airspace and came up with approx. 1.66 cf, which is practically perfect after mounting the subs. i have never ran a single chamber for 2 subs before, and still don't know if i am going to this time. i may put a divider/brace in the middle of them to seal off each chamber but i haven't decided yet.

looks like i am going to have to wrap the box first, then attach the rear amp mount and wrap over that, then the front and finish the wrap. if i mounted everything first i don't think i would be able to get to the bottom of the subs with my stapler. if all goes right i'll have more progress this weekend.