Took the time to take a few snapshots as well.
This picture is at a bit of a funky angle, but it is a shot from the #3 runner up towards the flange and turbine housing. The lip you see on the left is actually the turbine housing PROTRUDING into the exhaust stream!! The exhaust flow would go from right to left in this picture so you can really see there is merit to at least a match to the turbine housing for increased performance. After portwork this will be eliminated and better flow quality will be realized.
This shot is of the flange on the manifold and shows the scribe to a gasket match. The scribe line is ~.135" from the current edge.
This shot is of the turbine housings. A bit more on the width is going to be removed here as well. ~.160"
