Just a couple ????s
What Turbine modifications do you plan on performing?
Cutting too close to the turbine wheel has shown be a lose/lose. It will reduce Mass Flow AND Efficiency.
Don't you think that inhibiting heat transfer via Ceramic Coating is completely counterproductive to the goals of porting a Turbine?
Do you think the coating thickness(.006-.012") will completly negate any metal that was removed?
Will you be willing to share the manufacturer and part # of the ceramic coating you'll be using?
We currently used a lot of Henkel and Dupont products
Will you be testing every combination of ported/non-ported/coated/non-coated ?
It would be most interesting to see the results of just a ported compressor housing over the baseline.
__________________
"Just because someone goes fast doesn't mean you should do whatever you think they did.
This path assumes they knew what they were doing, which isn't necessarily the case"..........RB Racing
Last edited by duster360 : 04-29-2008 at 09:05 AM.
|
