Quote: Originally Posted by
1badsrt-4 
what do i have to do to my wot box i have now
When the software is ready, you will download it to your WOT Box using the serial cable provided.
Then you will need to make the following wiring changes before enabling the 2-step:
- Clutch signal moves from the yellow wire to the green wire.
- Yellow wire gets connected to the Violet / yellow wire of the OBD connector
- Cut all 4 fuel injector high side wires and wire them to the 16 AWG black wire near where you connected it to the ignition coil high side.
That last change allows the WOT Box to cut fuel and ignition simultaneously, which is needed for good control of the 2-step RPM.
However, you can't make these changes to your wiring until you have the new software. Otherwise, your car will go crazy every time you go into WOT.
I will post new wiring diagrams that will describe this in greater detail when the software is ready.
