Use the yellow HEET if need small amounts of methanol
Use washer fluid if need a little methanol and water
Use VP M1 if need large quantities of methanol.
Only use as pure a methanol as you can find, VP M1 is a good example of near pure methanol, VP M3 is an example of methanol with additives that will over time cause problems with you're W/A injections systems components.
Only use distilled water and not tap water.
The use of tap water over time will allow for the build up of small particles that will cause issues. Systems with small nozzles or jets are more prone to having problems with tap water.
Only through testing will the user be able to tell what mix of how much water to methanol works best. Typically, straight distilled water is not as good as a mix, and 100% methanol is wasted if not tuned for = start with a 80/20 water methanol mix and then test and then up the methanol ratio in 10% increments till theres no gains by adding more.
I found that I had great results with a 70/30 mix. I'm in NJ, it was summer time and had access to 93 octane pump gas.........my car running in south cali for instance might have needed closer to a 50/50 mix for the same results.
|
