cranking, not starting
So I got my SRT4 wired this nice long weekend, and when I went to fire her up, she cranked and never fired up. I think there is a major problem, because she doesn't keep cranking. It'll get like two or three spins and then it sounds like detonation. I don't know what it actually is.
I'm using a Super420A, NGC code that came with the unit(29q off the top of my head), and NGC msq that came with the unit. When I load that and put it on my JimStim with pin 6 on, it doesn't read the crank signal properly. It'll read 800 rpm tops and freak out or not read at all any higher than that. It won't constantly fire the LEDs like it would before I burn the msq. They only light up for that breif instance that it senses 800 rpm.
I'm kinda confussed as to which code versions and msqs I can use with an NGC crank. Also, which settings within that code should I look for to make sure that the msq will work on ngc?
I've tried different code/msq combinations and some either don't rev to/past 5000 rpm, or it totally freaks out above 900 rpm on my JimStim.
I don't think its my sim cause before I load an msq, it'll rev past 8000 no problem in MT.
I haven't tried starting my car without an msq because I don't know what I'm looking for to make sure its configured right for ngc.
__________________
Quote: Originally Posted by moltenice
. . . And the PCM knows.... THE PCM KNOWS ALLLLLLLLLLLLLLLLLLLLLLLLLL
I farted once and the PCM pulled timing on me until i rolled down the window... so go figure... 
Last edited by 2K4NightRiderSRT : 12-12-2007 at 07:56 PM.
Reason: not fixed
|
