How To Install Stock Location Overflow
Tools:
1. 10mm deep socket/ratchet/extension
2. Pliers
3. Flathead screwdriver
Item needed:
1. 3/8" hose clamp
2. Stock coolant cap/line
3. water/coolant
Installation:
Make sure car is NOT hot! Start off by removing the coilpack from the car along with any heatshield thats in the way. Remove the 10mm nut and screw holding the stock resevoir in. Remove the originall resevoir from the firewall and strip off the line and cap. Put these onto the new resevoir using a 3/8" hose clamp. Re-install the new overflow and top it off with 16oz of coolant/water(a normall size water bottle is 16oz) Snug everything up, re-install heatshield and coilpack. Reconnect the coolant line to the thermostat housing and start it up. This resevoir is slim enough, you should be able to put it in without having to remove your external wastegate or dump tube depending on your kit. In fact we didn't have to remove anything to install this bad boy on Jasons car(50trim setup) it just easily slid back there and bolted up no problems
