make sure your vac lines are set up the way it says in ravers post, you want to be using both top and bottom ports of the w/g. it's also normal for the boost to jump right to the psi setting of the w/g spring and then take 400 or so rpm to build to full boost, welcome to the land of 50 trim lag.
__________________
This post is completely ENVIRONMENTALLY GREEN. It was prepared using 100% recycled words and recovered hot air and other gases from the exhaust of the private jet Al Gore used to fly over to Norway and pick up his Nobel Prize. It has been further environmentally corrected and enhanced through the use of Intelligence Offset Coupons.
|
