Quote: Originally Posted by vegasDSM
Quote: Originally Posted by Dusty
Anyone with the 16g or 20g kit, please let me know how you hooked up the map clamp (hans map clamp). Hahns sent a drawing of how to hook it up, it shows the mapper red wire to the map sensor middle wire and the mapper black wire to the map sensor far left wire. But I have heard people use the mapper red wire to the far right sensor wire and the black to the middle?
find out which wires need power, ground, and signal...
then use a volt-meter to determine which wires are power, ground, and signal on the sensor...
do not go by middle, pass side, and dr. side... that's rediculous and whowever you are talkin with should be shot...
working with my map/tip clamp (and sensors during install) i found that some of the wires were the wrong color (comparing against several writeups and the FSM)...
by using a volt-ohm meter, you cant go wrong..
cheers
As far as middle, pass side, and dr. side for the wiring I was going off this thread -
Hahn PortFueler Map Clamp Install?. Its not the right way to go about wiring something, but its not rediculous, theres only 3 wires. But thats why I asked on the hahn thread to see if anyone could let me know what colors the taped the red and black wires off the fuel mapper to the sensor.
Anywas I talked to Aaron and hahn and he said red wire from the mapper goes to the darkgreen with red strip wire from the sensor and the back goes to the middle from the sensor. Whats bad is hahn sent me the wrong mapper install picture, and its not even color coded, it just shows left wire, middle wire and right wire. I think I just use a volt meter.
