Quote: Originally Posted by scottw03
Ok, installed mine. Everything went smooth for the most part.
Only problem that I had was trying to attach the MAP wire (I have the TCS with the 2 step so I need this wire). One my MAP Sensor I have three wires. One Orange, one black or red (this is the center wire) and one light green with red stripe. Now looking at the pinout picture it says it should be pin 1. But I am trying to figure out which one is pin 1 and from what direction should I be looking at the plug. The end that plugs into the sensor or the end that the wires are pushed into?
Sorry I just don't want to try the 2 step out and have something bad happen.
Hey what is the button on the box for though?
The MAP wire doesn't do anything right now, so you can just leave it out. Just bundle the excess wire from the WOT Box out of the way and go have fun. :-)
What's the button on the box for? It lets you turn it on and off, and if you hold it down it sets the amount of kill time. See here:
http://npcomplete.pbwiki.com/WOT+Box...ns#Programming
