Include

[05SRTFOUR]

First off...this should be a sticky!! This vac diagram thread benifits EVERYONE with an srt!! STICKY THIS!!!

I am tired of 100 messy vacuum line threads, so here is my attempt to make ONE clean and to the point thread that will benifit EVERYONE.

A few things need to be said so that they are seen on the 1st page and to eliminate confusion further on...

- Once you finish whatever vac setup you choose, you NEED to readjust your boost to whatever you were at before Taking control AWAY from the pcm causes you to boost less because you are strictly running off of the strength of the wga spring rather than 'stock' boost levels

- If you have a 2005 srt you NEED to keep the white line intact with the tps sensor

If you have a 2003/4 you do not need the white line and you can remove it at cap the nipple at the sensor on the firewall.

- Stock/stg2 wastegates do NOT have ptb (part throttle boost) issues. Therefore the setups regarding the stock/stg2 wga would simply give you better throttle/turbo response being that there are no more messy lines and t's everywhere.

- The line coming off from the brake booster with 2 little green dots and a cap at the top does NOT literally come off of the brake booster. I am just showing you the area to look at to find that. It is in between the block and the battery. The intake and blue lines connect to it. If you look under your intake piping you WILL find it.

- The cap at the top of the line that comes off of the brake booster was originally connected to the 3/8" elbow on the intake tube. CAP the intake nipple, remove the line completely, and cap the nipple at the top of the check valve line that i just talked about.


Ok...here they are...





Please, please, PLEASE read everything i stated above and PLEASE find the correct diagram that accomodates your mods before you go asking for a diagram that is already given to you....

Thanks.