First you need 1 can of night shade, some rubbing alcohol and a paper towel, 1 can of clear coat, and about 1 hour.
first thing you want to do is clean the surface of the object with the rubbing alcohol by putting some on a paper towel and rubing the surface untill all dirt, grease, and oil is gone, Wait tell it is dry, now remember do not touch the surface after you cleaned it because your fingers have oil on it and it will leave a little void where the night shade will not stick!
After the surface is dry from cleaning it you are going to want to shake the can of night shade for a good 30-60 sec to mix it all up! then your going to want to spray a
light coat in an even back and forth motion so it is aplied evenly. this is one coat...
after about 5-10 min after the first coat, it should be dry or almost dry, your going to want to blow on the surface to remove any dust that may have landed on the surface, but dont touch it because you will leave a finger print. after shaking the can again do another
light coat doing the side to side motion. This is 2 coats....
then when it is dark enough for your liking your going to want to clear coat it to leave a shiny apperance. So after you have let the last coat dry your going to want to blow all the dust off of the surface and after shaking the can for a good
minute your going to want to spray a
very light coat of clear on the surface. let it dry for about 10 min. and do another very light coat, and keep doing it untill you have some where around 5 coats......let it dry for a good 2 hours before touching it, unless you want some finger prints in the finished product.....no if you mess up anywhere in the process you can use the alcohol to remove the tint, but the alcohol will NOT remove the clear coat so if you messed up the clear coat your going to need to use carb cleaner/brake cleaner to remove the problem.....but remember when you use alcohol or carb cleaner you have to start all over again...
finished!
[/img]
