Uego gauge to Non uego EMS
How 2:
1]Take the White wire coming off your AEM Gauge.
2]Run the white wire down by the Factory PCM.
3]Open the harness of the Orange PCM. Locate the Black wire with dark green stripe. C2-31 is the location if you need it.
4]What I did was cut the black/green wire in half. Connect the PCM side of the wire to the white wire coming from you AEM gauge. Soder and retape the harness[plug back into PCM]
5]Go to Setup/Sensors/O2#1/02 wizard... select AEM Gauge
6]Then check out the volts that the EMS is seeing and make sure they match up to your AEM gauge. You can adjust the gain by Selecting Setup/Sensors/O2#1/options. You can check the volts by selecting Setup/Sensors/O2#1/parameters.
Dont forget to change the cal table from METH to Gasoline a/f. Do this by going to Configure/Units/A-F units/ Af gasoline
__________________
10.62@133.8 '05 SRT-4 Neon
11.74@120 '08 SRT-4 Caliber
Worlds Quickest/Fastest CSRT-4 |
