Quote: Originally Posted by RuizGT
Quote: Originally Posted by vschaos
Quote: Originally Posted by RuizGT
What's weird is my autotune has never kicked on, judging by my datalogging runs, and even when I datalogged the dyno run, should it?
Umm did you even hook it up? When you have the program open and are viewing the rpm, mph, etc does the air/fuel monitor work? You have to hook up the FTM to your wideband output so it can get a reading and adjust as it should. Also check your settings for the autotune...is it even turned on? You can tell the autotune when to turn on based on throttle percentage, etc.
Yeah, everything is hooked up, enabled at 80% throttle, 9 on the sensitivity, and 11 on the maximum/minimum correction, set for 11.9, I'm sure it's enabled, maybe it just hasn't had to correct for it if the tune is close enough?
Well when you datalog what does your air/fuel stay at to redline? Do you stay at a constant 11.9 air/fuel ratio? If your not staying at the 11.9 air/fuel to redline then the autotune should be working. The autotune should be pulling or adding fuel to make you have a consistant 11.9 mix. If for some reason you do stay at a 11.9 to redline without the autotune working I pat you on the back for a very well tuned fuel map!
