Quote: Originally Posted by haljensen1
Calcu; Thanks for the idea and the photos. Just did mine, must have taken all of 20 minutes. All you need are two 1" long 5/16" bolts, four 5/16" (or 3/8") fender washers and two 5/16" nuts. The only tools needed are a screw driver to pry the push fasteners from the straps on the bumper cover and a couple of 1/2" wrenches to tighten the bolts. I had all the parts in my junk box and was amazed at how easy it was to roll the cover. Now my Exhaust Depot single 3" turboback doesn't require the fake outlet on the passenger side. it took me longer to remove the welded in fake outlet than it did to roll the bumper cover.
Must be an optical illusion but the car looks lower and wider from the rear now.
Above is all you need to complete rolling the cover. Don't even need to jack the car up, on your back in the driveway works fine.
